Having achieved a more three dimensional effect by shaping and doming the etched fossil shapes to make the cufflinks, I wanted to play around a little bit and see what other pieces this design could work with.
Having etched and pierced out the spiral fossil design in two sizes, I thought I'd start with the small piece (a little more tricky to work with as the detail is finer, but less to lose if all goes awry) and adapt the design into a pendant. Although I now know it works and will no doubt be tempted to make a plain silver version, I wanted to enhance this piece with a small gemstone. I chose an ice (or sky) blue topaz, only 4mm in diameter, but which I thought would provide a good focal point.
After some careful preparation of the piece with files and emery paper, I constructed a bezel to fit the stone from bearer wire and drilled holes into the pendant where I wanted to place both the gemstone and the bail. Before marking out and piercing the hole for the bezel, I used a doming block and punch to raise the design into a convex form.
'Fossils in Silver' Pendant - raised design element
Above you can see the result of forming the metal. Once the bezel was fitted and soldered and the bead bail soldered in place, a thorough cleaning and finishing had to be completed before the stone was set. A final buffing around the bezel to remove any inadvertent setting marks and a good polish and the piece was complete.
The finished pendant is now with the Assay Office for hallmarking and I'm ready to tackle the larger version for which I've reserved a stunning 7mm round London blue topaz - can't wait to see the result!
Add a Comment